Campbell 21X Dokumentacja Pobierz pdf (Strona 40)

Number 4250-2010

Revision 0.1

Date MAY 1996

Page 21 of 37

EXECUTE Execute the Handar DCP communications program "TERM" from

PROGRAM the PC computer.

When the "TERM" setup screen (see Figure 4-4) is displayed on the

computer screen, press F2 to switch to the correct baud rate (300

baud).

Connect the serial port of the PC computer to the DCP

programming port (see Figure 4-2 for location) using the DCP

programming cable. After the connection is complete, the "TERM"

programming screen of Figure 4-6 should be displayed on the

computer screen.

Initiate the program download by pressing the F6 key.

The next screen prompt displayed is "LOAD PS PROG->DCP."

Press ENTER in response to this prompt.

The screen prompt "ENTER NAME OF PROGRAM FILE:" is then

displayed. Enter 540ROT.DCP to program a Handar 540 DCP. To

program a Handar 570A DCP, enter 570ROT.DCP.

While the program is loading, the message "P LOADING

PROGRAM" will be displayed. Upon completion of the download,

the message "P DONE" will be displayed. The "P" at the beginning

of a display message indicates that the DCP is in the "PROGRAM"

mode. An "R" at the beginning of a message indicates that the DCP

is in the "RUN" mode.

EDIT Procedures for editing the site-specific parameters are as follows:

PARAMETERS

Editing commands (the boldfaced character) used in these

procedures are as follows:

• I Station ID

• J DCP time

• S Time remaining before next scan

• T Time remaining before next transmission

• M Data channel select

• N Define Sensor Type

• K Program GOES/Radio

• V Scroll Down

• U Scroll Up

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Brak uwag

Campbell 21X Dokumentacja Strona 40