Campbell CS106 Instrukcja Obsługi Pobierz pdf (Strona 11)

CS106 Barometric Pressure Sensor

Improper wiring may damage the CS106 beyond repair.

WARNING

3.3 5-pin Screw Terminal Plug Connector

The datalogger connects to the CS106 via a 5-pin screw terminal plug

connector. This connector is removable and may be replaced. The

replacement connector may come with a connector key attached to it to ensure

that the connector is plugged into the CS106 right side up (see Figure 3-3).

When the connector is right side up, it will easily plug into the barometer.

FIGURE 3-3. Connector Key Attached to

5-pin Screw Terminal Plug Connector

A 5-pin screw terminal that is plugged in upside down

will damage the sensor—perhaps beyond repair.

WARNING

3.4 Mounting in an Enclosure

To prevent condensation, install the sensor in an environmentally protected

enclosure, complete with desiccant, which should be changed at regular

intervals.

Failure to protect the sensor from condensation may result

in permanent damage.

CAUTION

The CS106 is typically mounted in a Campbell Scientific enclosure next to the

datalogger. Campbell Scientific also offers the ENC100 for situations where it

is desirable to house the CS106 in its own enclosure (see Figure 3-4). The

ENC100 is a 6.7-in. x 5.5-in. x 3.7-in. enclosure that includes a compression

fitting for cable entry, a vent for equalization with the atmosphere, a backplate

for mounting the CS106, and hardware for mounting the ENC100 to a tripod,

tower, or pole.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Brak uwag

Campbell CS106 Instrukcja Obsługi Strona 11