Campbell AVW200 series Instrukcja Obsługi Pobierz pdf (Strona 46)

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules

5.6 Settings Editor

The Settings Editor in DevConfig can also be used to enter the Deployment

parameters (see FIGURE 5-2). Refer to Section 5.2, Deployment Tab

(p. 26),

and Section 5.3, Data Monitor

(p. 30), for a description of the setting parameters.

5.7 Terminal

You can monitor the AVW200 with terminal commands via the terminal

emulator in DevConfig or LoggerNet. You can also use a terminal emulator,

such as HyperTerminal or ProComm.

To enter terminal commands, first connect the RS-232 port of the AVW200 to

a serial port on your computer using the 10873 RS-232 cable (shipped with the

AVW200). After specifying the appropriate COM port (port to which the

AVW is attached) and communication baud rate (AVW baud rate = 38400),

press Carriage Return (CR) four times or until the AVW200> is returned. A

description of the available terminal commands and the values returned for

each command are listed in the TABLE 5-2.

TABLE 5-2. Terminal Mode Commands

Command Description Return Values

1 Make VW measurement

on channel 1

6 values (frequency, amplitude,

signal to noise ratio, noise

frequency, decay ratio, thermistor

resistance)

2 Make VW measurement

on channel 2

6 values (frequency, amplitude,

signal to noise ratio, noise

frequency, decay ratio, thermistor

resistance)

3 Company, Model Info. Company, mode, and PakCode

information

4 Status Table Status table

5 Public Table Public table

S or s Set the Date/Time Set the date and time

G or g Get the Date/time Get the date and time

Mcmm Make VW measurement

on channel (c) and mux

channel (mm)

6 values (frequency, amplitude,

signal to noise ratio, noise

frequency, decay ratio, thermistor

resistance)

H or h Help menu Returns list of commands

The Mcmm terminal command was added to OS version STD.02.

Customers with OS version STD.01 can get this terminal

command by downloading a new OS (refer to Section

5.4, Send

(p. 32)).

NOTE

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 113 114

Komentarze do niniejszej Instrukcji

Brak uwag

Campbell AVW200 series Instrukcja Obsługi Strona 46

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Campbell AVW200 series