Campbell CM10K Dokumentacja Pobierz pdf (Strona 27)

2. Connect the battery. Connect the battery to the charge regulator in the middle section

labeled “BATTERY” by running cables from the positive and negative terminals of the

battery (be careful with the polarity: + with +, − with −). The operating manual suggests

connecting the negative terminal first, followed by the positive one. Take care not to

cross the wires to avoid electrical shock. Once positive and negative wires are attached to

the battery they become live and full of electricity.

3. Route solar panel cables to the enclosure. Route the cables coming from the solar panel

along the tower and secure them with plastic ties. Continue routing the cables up the

tower and into the enclosure.

4. Cut the wires. In order to connect the solar panel to the charge regulator, the cables from

the panel must be cut, so the wires are exposed, leaving a small portion at the end of the

wire bare.

5. Connect the solar panel. Attach the cables that were cut in the previous step to the left

hand side of the power regulator in the section labeled “SOLAR.” The negative lead

should be attached first and then the positive one (remember to check the polarity: + goes

with +, - with -).

6. Connect the data logger. Attach two cables to the “LOAD” section of the charge

regulator and connect them to the data logger. As with the other two connections, start

with the negative terminal first (attach to the “G” slot on the data logger) and then

connect the positive terminals (“+12V” on the data logger). You might consider using a

splitter and connect the cables coming from the solar panel into the splitter instead.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 94 95

Brak uwag

Campbell CM10K Dokumentacja Strona 27